I have a BambuLabs A1 and a textured PEI plate. I’m using PETG filament
I’m printing my first larger footprint project and isn’t going great after dozens of flawless smaller prints. The model curls up at the corners (warping) while it is printing.
I attempted to help by adding a raft and brim, but it still happened. The plate has been freshly cleaned too, so there shouldn’t be oils. I don’t enclose the printer because my garage’s ambient temp is typically pretty hot, between 95-110 degrees this time of year and rarely fluctuates. I say this not really knowing what enclosing the printer might bring it up to inside. I just haven’t had any problems that required it so far… so?
After reading up on the problem my first thought was to increase the temp of the print bed to help keep the layers from cooling too fast. I usually use BambuStudio’s default settings for PETG. But what temp to set it to?
Also, considering adding adhesive to the plate, but not sure what would work well with the textured PEI plate.
Any thoughts to help me out? Thanks!
Decrease part cooling. Especially for small prints, when the fan kicks in it can cause sudden cooling of the top part while the bottom stays hot, causing warping. Bed adhesion is a separate issue, in that case the bottom layer should still be flat.
My PETG profile has no cooling for the first 2 layers, then gradual ramp-up until layer 5
Petg is really sensitive on bed adhesion. Make sure after cleaning the plate only touch the edges. If you touch anywhere in the middle that leaves enough oil to make bed adhesion an issue. I clean my plate with rubbing alcohol mix. And found out after many print failures -no touchy!
100% this, bed cleanliness is the first thing I’d look at for any adhesion issue. Dilute soap and water works well too, just pay attention to your surface, some don’t like any solvents or water, just a wipe with micro fibre.
Petg also likes an enclosure, temperature variance of the room likes to cause warp too. Geometry could be an issue.
1st thought is bed adhesion. Clean better? 2nd thought is filament parameters. Whose PETG filament are you using? Bambu’s default are for their filament, yours may be different. 3rd, cooling at the edges, the A1 has no box around, IIRC. Can you make a DIY cover to hold the heat in or raise the room temperature or avoid cool drafts.
Post pics?
@KingDingbat I don’t have PETG experience but I recently printed with ASA for the first time and it came away from the plate at the edges.
Washing the plate helped but only Glue stopped the issue entirely.
3 failures before I glued, zero problems after Glue.
Do you have a smooth plate? Try glue and a smooth if you can. Also can still use glue on the texture plate too. Recommend one of the fancy 3d printing glue sticks over repurposing some random gluestick. Also try “mouse ears” little circles around the corners. Some slices have this as option but you can build them manually too. Search mouse ears and your slicer for instructions.
